Celebrity L4-151 2.5L (1982)
Fig. 196 Typical C-3 System Wiring Harness Repair
-
Engine compartment wiring harness must be replaced with an exact replacement--if damaged or defective.
-
Single wires can be repaired as shown--Fig. 196. Use proper gauge wire--with high temperature insulation--and solder all connections--to
ensure the best possible bond at splices.
NOTE: Before repairing or replacing any C-3 system component check wiring connections as follows:
1.
Disconnect electrical connectors from component and check for bent, broken or dirty terminals and mating tabs.
2.
Clean, straighten or replace terminals and connectors as needed.
3.
Connect electrical connector and repeat test procedure.
