Celebrity V6-173 2.8L (1989)
Drive Belt Tensioner: Service and Repair
INSPECTION
1.
Run engine, with no accessories on, until normal operating temperature is reached. Turn engine off and read belt tension using belt tension gauge
J-23600-B or equivalent. Place gauge halfway between alternator and power steering pump.
2.
Start engine, with accessories off, and allow system to stabilize for 15 seconds. Turn engine off. Using a 15 mm socket, apply clockwise force to
tensioner pulley bolt. Release force and immediately take a tension reading without disturbing belt tensioner position.
3.
Using a 15 mm socket, apply counterclockwise force to tensioner pulley bolt, raise pulley to eliminate all tension. Slowly lower pulley to belt and
take a tension reading without disturbing belt tensioner position.
4.
Average three readings. If average is not between 50-70 lbs. and belt is within tensioner's operating range, replace belt tensioner.
Fig. 17 Replacing Belt Tensioner
REPLACE
1.
Remove serpentine drive belt.
2.
Remove tensioner attaching bolts, then tensioner, Fig. 17.
3.
Reverse procedure to install, torquing all bolts/nuts specifications.