chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Customer Interest:|891207A > < A/T - Intermittent Rattle/Clicking Loudest In 3RD Gear
Page 2
background image

BULLETIN COVERS:

An intermitent rattle and/or clicking noise caused by Lo-Reverse parallel grooved fiber plates in 1989 THM 125C/HYDRA-MATIC 3T40 transaxles.
This noise is most evident in the 3rd gear range.

DATE OF PRODUCTION CHANGE: (Figures 1 and 2)

New smooth surface fiber plates for the Lo-Reverse clutch went into production May 5, 1989, (Julian Date 125), for Willow Run built HYDRA-MATIC
3T40 transaxles and May 15, 1989, (Julian Date 135) for Windsor built HYDRA-MATIC 3T40 transaxles.

SERVICE ACTION:

If a customer comments about a rattle and/or clicking noise condition in any THM 125C/ HYDRA-MATIC 3T40 transaxle, the Lo-Reverse fiber plates
should be replaced with new smooth surface fiber plates.

SERVICE PARTS INFORMATION:

When ordering new Lo-Reverse fiber plates for this condition refer to the following part numbers:

Part Number

Package Description

8665960

Overhaul Kit

8666667

Lo-Rev Clutch Pack

Parts are expected to be available on 9/1/89. Until then normal part orders will not be accepted by GMSPO. Only verifiable emergency VIP orders will
be accepted. SPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the part will be
shipped premium transportation at dealer's expense. All other order types will be canceled as incorrectly ordered while the 400 control is in place.

SERVICE MANUAL REFERENCE:

Whenever servicing any THM 125C/HYDRA-MATIC 3T40 transaxle refer to the procedures outlined in the Unit Repair Section of your Service
Manual.

Customer Interest:|891207A > < A/T - Intermittent Rattle/Clicking Loudest In 3RD Gear