Celebrity V6-173 2.8L VIN Z 2-bbl HP (1984)
Whenever a vehicle subject to this campaign is taken into your new or used vehicle inventory, or it is in your dealership for service in the future you
should take the steps necessary to be sure the campaign correction has been made before reselling or releasing the vehicle.
Owners of vehicles recently sold from your new vehicle inventory are to be contacted by the dealer, and arrangements made to make the required
modification according to instructions contained in this bulletin.
Number :
84C08
Section :
7C
Page No.:
3
SERVICE PROCEDURE
1.
Open hood.
2.
Disconnect brake pressure warning connector at master brake cylinder.
3.
Remove master brake cylinder attaching nuts and pull master brake cylinder forward to permit clear access to the left shock absorber housing. (It is
not necessary to open the brake pipes.) Care should be taken to prevent foreign material from entering booster opening with master cylinder
removed.
4.
Crease template (part of kit) on dotted line and position template (printing outward) against the forward and inboard strut attaching stud washers.
5.
Center punch the shock absorber housing using the template as a locater (be sure the template is in contact with the top surface of the shock
absorber housing) and drill a 7/32" diameter hole. Use extreme care not to contact the suspension spring with the drill.
Figure 1 - Pop Rivet
6.
Pop rivet (part of kit) the clutch cable retaining clip (part of kit) to the shock absorber housing using the lower hole of the retaining clip with the
clip vertical and downward. (Figure 1)
7.
Drill a 7/32" diameter hole through the shock absorber housing using the upper hole of the retaining clip as a pilot and pop rivet. (Do not contact
the suspension spring with the drill).
