Celebrity V6-191 3.1L (1990)
Steering Column: Service and Repair
Ignition Lock Cylinder - On Vehicle
WARNING: On vehicles equipped with Airbags, disable airbag system prior to performing service procedures.
1.
Remove turn signal switch as outlined under TURN SIGNAL SWITCH.
2.
Remove buzzer switch and spring clip. On 1990-92 models, ignition key must be removed from lock to remove buzzer switch. On 1991-92
models, switch and spring clip are one assembly.
3.
Turn lock cylinder to Run position on 1989 models or Lock position on 1990-92 models, then remove lock cylinder retaining screw and the lock
cylinder.
4.
To install, rotate lock cylinder to the stop while holding housing. Align cylinder key with keyway in housing, then push lock cylinder into housing
until fully seated. Lock cylinder must be in Run position to install buzzer switch.
5.
Install lock cylinder retaining screw, then the buzzer switch, turn signal switch and steering wheel.
