Chevette L4-98 1.6L (1982)
FIGURE 2
3.
Shake vigorously for 10 to 15 seconds.
4.
Carefully loosen stopper to release pressure.
5.
Close the stopper and shake vigorously again for 10 to 15 seconds.
6.
Carefully loosen stopper to release pressure.
7.
Put the graduated cylinder on a level surface for approximately 5 minutes to allow adequate liquid separation.
If alcohol is present in the fuel, the volume of the lower layer, which would now contain alcohol and water will be greater than 10 ml. For example, if the
volume of the lower layer is increased to 15 ml (Fig. 2), it would indicate at least 5 percent alcohol in fuel. The actual amount of alcohol may be
somewhat greater because this procedure does not extract all of the alcohol from the fuel.
One source that the 100 ml cylinder is available from is:
SARGENT-WELCH
-24747 CYLINDERS - Single Graduated, Stopper, KIMAX (Kimble No. 20039). Graduated and provided with stopper closure. With heavy molded
hexagonal base. Calibrated to contain at 20~C. For replacement stoppers, see S-77416.
Cap.,
Subdiv,
Stopper
