Citation V6-173 2.8L VIN X 2-bbl (1982)
FIGURE 4 - SEAL INSTALLATION KIT
4.
Lubricate the inside of the sizing tool (J-29569-2) with petrolatum or equivalent. Push the sizing tool down over the seal and turn. Remove the
sizing tool and inspect the seal to be sure that it is properly seated in the groove (Figure 3, Page 4).
5.
To install the seal on the other end of the shaft, turn the shaft over and repeat the above procedure.
New Design Band Anchor Plug
FIGURE 5 - BAND ANCHOR PLUG
Beginning in mid-June, 1981, all THM 125 and 125C transmissions were assembled with a new design band anchor plug. The new design band anchor
plug has a tab which holds the part in place (see Figure 5).
FIGURE 6 - PAST DESIGN ANCHOR PLUG
