Citation II L4-151 2.5L VIN R TBI (1984)
PARTS INFORMATION
Parts required to complete this modification are to be obtained from the General Motors Warehousing and Distribution Division (GMWDD). To ensure
that these parts will be obtained as soon as possible, they should be ordered from GMWDD on a C.I.O. order with no special instruction code, but on an
advise code (2).
Description
Part Number
TBI Fuel Feed Pipe
10029649
SERVICE PROCEDURE
Figure 1
Figure 2
1.
Relieve fuel pressure.
a.
Remove fuse marked "Fuel Pump" from fuse block in passenger compartment.
b.
Crank engine - engine will start and run until fuel supply remaining in fuel lines is exhausted. When engine stops, engage starter again for 3
seconds to assure dissipation of any remaining pressure.
c.
With ignition "OFF", replace "Fuel Pump" fuse.
CAUTION: Unless this procedure is followed before replacing fuel pipe, fuel spray could occur.
2.
Disconnect negative battery cable.
