Citation II L4-151 2.5L VIN R TBI (1984)
removal of pinion and valve assembly from housing, mark second location of stub shaft flat or notch on housing. The second mark is used to
position flat or notch prior to reassembly.
FIGURE 5 - RING, SEAL AND BEARING REMOVAL
10.
Remove stub shaft dust seal, stub shaft seal, stub shaft bearing annulus assembly, pinion and valve assembly, with spool shaft retaining ring,
and valve body rings attached.
11.
Remove valve body rings from pinion and valve assembly.
Important
Use care when removing rings from valve assembly to prevent damage to valve assembly.
FIGURE 6 - DRIVE PIN INSPECTION
