Cobalt L4-2.0L SC VIN P (2005)
Front Door Interior Handle: By Symptom
Technical Service Bulletin # 05-08-64-036B
Date: 060321
Interior - Door Panel Trim Fabric Pulls Away From Panel
Bulletin No.: 05-08-64-036B
Date: March 21, 2006
TECHNICAL
Subject:
Fabric On Door Trim Too Short (Replace Pull Cup With Wider Bezel Or Beauty Ring)
Models:
2005-2006 Chevrolet Cobalt
2005-2006 Pontiac Pursuit (Canada Only)
Supercede:
This bulletin is being revised to include procedures for vehicles both with and without power window/locks and update the warranty information . Please
discard Corporate Bulletin Number 05-08-64-036A (Section 08 - Body and Accessories).
Condition
Some customers may comment that the fabric on the door trim is pulling away from the pull cup.
Cause
This may be due to the bezel on the pull cup. It is not wide enough to account for the variation in the water cut jet process on the trim panel.
Correction
Replace the pull cup with a new design cup that has a wider bezel following the procedure below.
For vehicles without power windows and locks
1.
Remove the trim plate in the bottom of the pull cup with a small screwdriver.
2.
Remove the two screws.
3.
Remove the pull cup.
4.
Install the new pull cup with a wider bezel.
5.
Install the two screws.
Tighten
Tighten the screw to 2 N.m (18 lb in).
6.
Install the trim plate in the bottom of the pull cup.
For vehicles with power windows and/or locks
1.
Remove the trim plate in the bottom of the pull cup with a small screwdriver.
2.
Remove the two screws.