chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body - Interior Door Handle Clicking Noise/Inoperative|Page 14953 > < Body - Interior Door Handle Clicking Noise/Inoperative|Page 14951
Page 1
background image

Rear Door Interior Handle: By Symptom

Technical Service Bulletin # 05-08-64-030A

Date: 051102

Body - Interior Door Handle Clicking Noise/Inoperative

Bulletin No.: 05-08-64-030A

Date: November 02, 2005

TECHNICAL

Subject:
Interior Door Handle Inoperative Or Clicking Noise Heard When Opening Door (Replace Interior Door Handle)

Models:
2005-2006 Chevrolet Cobalt
2005-2006 Pontiac Pursuit (Canada Only)

Supercede:

This bulletin is being revised to add the Pontiac Pursuit. Please discard Corporate Bulletin Number 05-08-64-030 (Section 08 - Body and Accessories).

Condition

Some customer may comment that the door will not open from the inside or there is a clicking noise when the door is opened. The noise seems to come
from the door handle.

Cause

This condition may be caused because the cable barrel end to the door handle may not be seated properly, or the cable housing may not be properly
seated.

Correction

Remove the door trim and inspect the handle. If the cable barrel is not seated in the handle, apply pressure to the cable to lock it in. If the handle is
inoperative, replace the handle following the procedure below.

1.

Place the door trim in your lap and with your thumbs on the back side of the handle, twist the top of the panel downward. This will cause the
handle the come out the front.

2.

Remove the glue with an Exacto blade.

Important:

It is not necessary to glue the top of the handle to the trim panel. It is done at the plant for shipping purposes only.

3.

Install the handle in the door trim panel. Apply some pressure and it will snap in place.

4.

Install the door trim panel.

Body - Interior Door Handle Clicking Noise/Inoperative|Page 14953 > < Body - Interior Door Handle Clicking Noise/Inoperative|Page 14951