Cobalt L4-2.0L SC VIN P (2005)
^
Tighten the bolts to 9 Nm (80 inch lbs.).
3. Install the brake pedal assembly, with the accelerator pedal assembly to the vehicle.
4. Install the cruise control release switch, if equipped, to the pedal bracket.
5. Install the stop lamp switch to the pedal bracket.
6. Move the brake pedal assembly to the installed position.
7. Install the brake pedal bracket-to-steering column bracket bolt (1).
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
8. Loosely install the brake booster mounting nuts.
9. Apply a thin coating of lithium grease to the pushrod pin on the brake pedal.
10. Connect the brake booster pushrod (2) to the brake pedal.
11. Install the washer (3) and retaining clip (4) to the brake pedal.
12. Tighten the vacuum brake booster mounting nuts.
^
Tighten the nuts to 17 Nm (14 ft. lbs.).
13. Adjust the stop lamp switch.
14. Adjust the cruise control release switch, if equipped.
