Cobalt L4-2.0L SC VIN P (2005)
1. Using the J 38400, spread the top of the brakes shoes apart, then install the wheel cylinder to the brake backing plate.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the wheel cylinder mounting bolts (3).
^
Tighten the bolts to 16 Nm (12 ft. lbs.).
3. Remove the cap from the brake pipe end.
4. Connect the brake pipe fitting (1) at the wheel cylinder.
^
Tighten the fitting to 19 Nm (14 ft. lbs.).
5. Install the wheel cylinder bleeder valve.
^
Tighten the valve to 8 Nm (71 inch lbs.).
6. Install the brake drum.
7. Bleed the hydraulic brake system.
8. Install the bleeder valve cap.
9. Adjust the drum brakes.
10. Install the tire and wheel assembly.
11. Lower the vehicle.
