Cobalt L4-2.0L SC VIN P (2005)
14. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the park brake cable adjusting nut (1).
^
Tighten the nut to 3.9 Nm (35 inch lbs.).
15. Attempt to rotate the rear brake drums. There should be no rotation forward or rearward.
16. Fully release the park brake lever.
17. Verify the park brake is released by rotating the rear brake drums. The drums should rotate freely and exhibit no brake shoe drag.
18. If the drums do not rotate freely, repeat the park brake cable adjustment procedure.
19. Raise the park brake lever 3 detent positions and attempt to rotate the rear brake drums:
^
One of the brake drums should not rotate forward or rearward.
^
The other brake drum should not rotate forward or rearward, or should require substantial effort to rotate.
20. Raise the park brake lever one additional detent position and attempt to rotate the rear brake drums.
21. Verify that the left and right brake drums cannot be rotated.
22. Remove the wheel nuts retaining the brake drums.
23. Install the rear tire and wheel assemblies.
24. Lower the vehicle.
25. Position the park brake lever boot to the floor console and press the boot retainer into place to secure.
26. Release the park brake lever.
