Cobalt L4-2.0L SC VIN P (2005)
1. Insert the park brake cable through the cable bracket on the caliper.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the rear park brake cable guide (3) retaining bolt (2).
^
Tighten the bolt to 10 Nm (89 inch lbs.).
3. Secure the cable fitting to the cable bracket. Ensure that the retaining tabs (4) are fully seated.
4. Install the cable end (1) to the caliper park brake lever.
5. Install the rear tire and wheel assembly.
6. Insert the cable through the opening in the vehicle underbody.
7. Install the C-shaped retainer (1) on the park brake cable into the bracket at the rear axle trailing arm pivot.
8. Install and secure park brake cable pass-thru grommet (3) to the opening in the vehicle underbody.
9. If a new park brake cable is being installed, secure the underbody retainer (2) to the vehicle underbody.
10. If the park brake cable is being reused, install the park brake cable to the underbody retainer (2) and press the tab into place to secure.
11. Lower the vehicle.
