Cobalt L4-2.0L SC VIN P (2005)
2. Install the new lower HVAC case screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.8 N.m (15 lb in).
3. Close and secure the passenger compartment filter door.
4. Inspect the foam heater core seal on the lower HVAC case. If damaged, replace using Kent Industries adhesive black foam tape P/N 46480 or
equivalent.
5. Install the heater core into the HVAC module.
6. Install the heater core cover.
IMPORTANT: Make certain that the heater core cover is properly positioned and is fully seated on the HVAC module before installing the screws.
Be sure to install all heater core cover screws.
