Cobalt L4-2.0L SC VIN P (2005)
Fuel Gauge Sender: Service and Repair
FUEL SENDER ASSEMBLY REPLACEMENT
TOOLS REQUIRED
-
SA9156E Fuel Tank Lock Ring Remover
-
J 39765 Fuel Sender Lock Nut Wrench
REMOVAL PROCEDURE
CAUTION:
-
Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.
-
In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket when
reinstalling the fuel sender assembly.
1. Remove the fuel tank.
2. Release the retaining tab on the fuel tank retainer used to secure the fuel pump module pipes in position on the tank.
IMPORTANT: Take note of the positioning of the fuel tank rear shield prior to releasing the pump module pipe retainer.
3. Release the fuel pump module electrical harness from the retaining slot on the tank.
4. Disconnect the fuel pump module harness electrical connector from the fuel tank pressure sensor.
5. Using the SA9156E, or J 39765 (1), carefully rotate to release the fuel pump module retaining lock ring.
