Cobalt L4-2.0L SC VIN P (2005)
10. Remove the garnish molding from the upper lock pillar.
11. Remove the CPA from the roof rail module-left connector.
12. Disconnect the roof rail module-left connector from the vehicle harness connector.
13. Remove the LH door trim panel.
14. Peel back the door water deflector far enough to access the SIS-left.
15. Remove the CPA from the SIS connector.
16. Disconnect the SIS connector from the SIS-left.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the SIS-left go to step 3. To enable the roof rail module-left go to step 7, and to enable the seat belt pretensioner-LF go to step 10.
