Cobalt L4-2.0L SC VIN P (2005)
Important:
If the vehicle is brought in with an inoperative A/C system, replace the A/C refrigerant pressure sensor using the appropriate procedure in SI
and then perform the repair below.
1.
Open the hood.
2.
Remove the engine sight shield.
Notice:
DO NOT pull on the wiring clip to remove it from the fan shroud. The fan shroud may be damaged. Use a prying tool between the clip and the
ear on the shroud or use diagonal cutters to cut the retainer.
3.
Remove the wire retainer from the fan shroud and unplug the electrical connector from the fan.
4.
Plug the new jumper into the fan and plug the original fan wiring into the jumper.
5.
Press the wiring retainer on the jumper into the hole in the fan shroud where the original wire clip was located. Route the wiring so that it will not
come into contact with other parts.
6.
Install the engine sight shield.
7.
Close the hood.
Courtesy Transportation
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranty. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product recall is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that shuttle
service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General Motors Service
Policies and Procedures Manual for Courtesy Transportation guidelines.
Claim Information
Submit a Product Program Claim with the information shown.
Customer Notification
General Motors will notify customers of this program on their vehicle (see copy of customer letter shown in this bulletin).
