Cobalt L4-2.0L SC VIN P (2005)
10. Remove the headlamp/turn signal switch from the SIR coil module assembly.
11. Remove the wiper washer switch from the SIR coil module assembly.
INSTALLATION PROCEDURE
1. Install the wiper washer switch from the SIR coil module assembly.
2. Install the headlamp/turn signal switch to the SIR coil module assembly.
3. Install the headlamp/turn signal switch screws.
4. Verify the SIR coil is in the center position. Refer to Inflatable Restraint Steering Wheel Module Coil Centering in Steering Wheel and Column.
5. Slide the SIR coil assembly on the steering column and snap into place.
6. Connect the wiper/washer harness connector to the SIR coil module assembly.
7. Connect the headlamp/turn signal harness connector to the SIR coil module assembly.
8. Connect the SIR coil harness connector to the SIR coil module assembly.
9. Install the steering column covers.
10. Install the steering wheel.
11. Install the inflatable restraint steering wheel module.
12. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
