Cobalt L4-2.0L SC VIN P (2005)
1. Install a NEW fuel pump module-to-fuel tank seal (1).
IMPORTANT: The reservoir must be tipped slightly during installation to avoid bending the fuel level sensor float arm.
2. Tilt the pump module toward the rear of the fuel tank to enable the level sensor float arm to clear the tank opening. Install the fuel pump module to
the fuel tank.
3. Slowly lower the fuel pump module assembly into the tank. Ensure that the fuel level sensor harness connector is positioned properly.
4. Install the fuel pump module retaining lock ring over the module pipes and electrical harness, and into position on the top of the module.
