Cobalt L4-2.0L SC VIN P (2005)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the engine oil pressure sensor electrical connector.
3. Remove the engine oil pressure sensor from the engine oil cooler assembly.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the engine oil pressure sensor to the engine oil cooler assembly.
^
Tighten the oil pressure sensor to 22 Nm (16 ft. lbs.).
2. Connect the engine oil pressure sensor electrical connector.
3. Connect the negative battery cable.
