Cobalt L4-2.0L SC VIN P (2005)
center. With the AIR BAG fuses removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
6. Remove the right/passenger outer trim cover from the instrument panel (I/P) (3).
7. Remove the connector position assurance (CPA) from the I/P module connector (2).
8. Disconnect the I/P module connector (1) from the vehicle harness connector (2).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the I/P module connector (1) to the vehicle harness connector (2).
3. Install the CPA to the I/P module connector (2).
4. Install the right outer trim cover to the I/P (3).
5. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the BCM fuse center.
6. Install the BCM fuse center cover.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information.
SIR Disabling and Enabling Zone 6
SIR DISABLING AND ENABLING ZONE 6
