Cobalt L4-2.0L SC VIN P (2005)
the inboard seal properly by hand. Remove the tool.
Position the joint assembly at the proper vehicle dimension: 95 mm (3.75 inch).
14. Align the following items while latching:
^
The inboard seal
^
The tripot housing (2)
^
The large seal retaining clamp (3)
Crimp the seal retaining clamp with J 35910 to 176 Nm (130 ft. lbs.). Add the breaker bar (5) and the torque wrench (4) to J 35910 if necessary.
15. Check the gap dimension (a) on the clamp ear. If gap dimension is larger than shown, continue tightening until gap dimension of 2.60 mm (0.102
inch) is reached.
16. Fully stroke the joint several times to disperse the grease.
Delphi
Wheel Drive Shaft Inner Joint and Seal Replacement (Delphi)
^
Tools Required
-
J 8059 Snap Ring Pliers
-
J 35910 Drive Axle Seal Clamp Pliers
-
DT-47732 Drive Axle Swage Ring Clamp
Disassembly Procedure
