Cobalt L4-2.0L SC VIN P (2005)
8. Place approximately half of the grease from the service kit in the shaft inboard boot. Use the remainder of the grease to repack the housing.
9. Important: Ensure the trilobal tripot bushing (3) is flush with the face of the housing (1).
Install the trilobal tripot bushing (3) to housing.
10. Position the larger new boot retaining clamp (2) on the shaft inboard boot.
11. Slide the housing (1) over the tripot joint spider assembly on the shaft.
12. Slide the large diameter of the inboard boot (2), with the larger clamp (3) in place, over the outside of the trilobal tripot bushing and locate the lip
of the boot in the groove.
13. Important: The inboard boot must not be dimpled, stretched out or out of shape in any way. If the inboard boot is not shaped correctly, carefully
insert a thin flat blunt tool (no sharp edges) between the large boot opening and the trilobal tripot bushing in order to equalize the pressure. Shape
