Cobalt L4-2.0L SC VIN P (2005)
Tighten the rear transaxle mount to frame bolts.
^
Tighten the bolts to 60 Nm (44 ft. lbs.).
3. Important: Rotate the rear transaxle mount heat shield clockwise until the tab is seated on the mount bracket.
Hand start the rear transaxle mount through bolt.
4. Important: The front and rear transmission mounts must be allowed to settle with the through bolts loosened.
Loosen the front trans mount through bolt.
5. Tighten the transmission mount through bolts in the following order:
1. Tighten the rear bolt to 100 Nm (74 ft. lbs.).
2. Tighten the front bolt to 100 Nm (74 ft. lbs.).
6. Lower the vehicle.
Transmission Mount Replacement - Left
Transmission Mount Replacement - Left
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the underhood electrical center cover.
3. Disconnect the engine control module (ECM) harness connector (3, 4).
4. Disconnect the positive battery cables (1) from the underhood electrical center.
5. Disconnect the surge tank inlet hose from the surge tank.
