Cobalt L4-2.0L SC VIN P (2005)
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the front transaxle mount to the transaxle bolts, and tighten in sequence.
^
Tighten the bolts to 90 Nm (66 ft. lbs.).
2. Hand start the front transaxle mount through bolt.
3. Important: The front and rear transaxle mounts must be allowed to settle with the through bolts loosened.
Loosen the rear transaxle mount through bolt.
4. Tighten the transaxle mount through bolts in the following order:
1. Tighten the rear bolt to 100 Nm (74 ft. lbs.).
2. Tighten the front bolt to 100 Nm (74 ft. lbs.).
5. Lower the vehicle.
Transmission Mount Replacement - Rear
Transmission Mount Replacement - Rear
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting
