Cobalt L4-2.0L SC VIN P (2005)
Transmission Position Switch/Sensor: Adjustments
Park/Neutral Position (PNP) Switch Adjustment
^
Tools Required
-
J 41545 Park/Neutral Switch Aligner
Adjustment
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
3. Loosely install the transaxle range switch bolts.
4. Insert the J 41545 as shown and rotate the switch until the tool drops onto position.
5. Notice: Tighten the transaxle range switch bolts.
^
Tighten the range switch bolts to 20 Nm (15 ft. lbs.).
6. Remove the alignment tool.
