chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body - Rear Door Wind Noise|Page 17380 > < Power Window Switch Replacement - Left Front|Page 17371
Page 1
background image

Window Frame: Customer Interest
Body - Rear Door Wind Noise

Bulletin No.: 05-08-58-004

Date: August 22, 2005

TECHNICAL

Subject:
Rear Door Wind Noise (Apply Sealer)

Models:
2005 Chevrolet Cobalt
2005 Pontiac Pursuit (Canada Only)

Condition

Some customers may comment on wind noise coming from the rear door stationary glass.

Cause

This condition may be caused by the rubber seal surrounding the stationary glass not making contact to the door frame.

Correction

1.

Remove the rear door stationary door glass following SI Document ID 1549117.

2.

Apply 5 mm (1/4 in) bead of 3M(R) Bedding & Glazing Compound around the center of the stationary door glass frame.

3.

When reinstalling the stationary glass, there is a metal tang at the top of the division post. Pull the vent glass down and rearward until you hear this
metal tang seat into the square hole in the door frame. Refer to the arrow in the illustration above.

4.

Reinstall the door trim following SI Document ID 1549117. 

Body - Rear Door Wind Noise|Page 17380 > < Power Window Switch Replacement - Left Front|Page 17371