Cobalt L4-2.0L SC VIN P (2005)
Wiper Switch: Service and Repair
WIPERS/WASHER SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the steering column trim covers.
2. Disconnect the wipers/washer switch harness connector.
3. Remove the wipers/washer signal switch retaining screws.
4. Remove the wipers/washer signal switch from the steering column.
INSTALLATION PROCEDURE
1. Install the wipers/washer signal switch to the steering column.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the wipers/washer signal switch screws to 2 N.m (17 lb in).
2. Connect the wipers/washer switch harness connector.
3. Install the steering column trim covers.
