chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Recall - TCM Update For Shift Improvements|Page 741 > < Tire Monitor System - TPM Sensor Information
Page 1
background image

Technical Service Bulletin # 07153

Date: 070531

Recall - TCM Update For Shift Improvements

Bulletin No.: 07153

Date: May 31, 2007

PRODUCT EMISSION

Subject:
07153 - Transmission Control Module Calibration Concern - Reprogram Transmission Control Module (TCM)

Models:
Certain 2007 Chevrolet Cobalt

Equipped with 4T45E (RPO MN5) Automatic Transmission

Condition

Certain 2007 Chevrolet Cobalt vehicles, equipped with a 4T45E (RPO MN5) automatic transmission, may have had the transmission control module
reprogrammed with calibrations that do not provide desired transmission torque converter clutch and shift performance.

Correction

Dealers are to reprogram the Transmission Control Module (TCM).

Vehicles Involved

Involved are certain 2007 Chevrolet Cobalt vehicles, equipped with a 4T45E (RPO MN5) automatic transmission and built within the VIN breakpoints
shown.

Dealers are to confirm vehicle eligibility prior to beginning repairs by using the system below. Not all vehicles within the above breakpoints may be
involved.

-

GM dealers should use GMVIS.

For dealers with involved vehicles, a listing with involved vehicles containing the complete vehicle identification number, customer name, and address
information has been prepared and will be provided through the applicable system listed below. Dealers will not have a report available if they have no
involved vehicles currently assigned.

-

US GM - GM DealerWorld Recall Information

-

Canadian GM - GMinfoNet Recall Reports

The listing may contain customer names and addresses obtained from Motor Vehicle Registration Records. The use of such motor vehicle registration
data for any purpose other than follow-up necessary to complete this recall is a violation of law in several states/provinces/countries. Accordingly, you
are urged to limit the use of this report to the follow-up necessary to complete this recall.

Calibration Information

Do not attempt to order the calibration number from GMSPO. The calibration numbers required for this service procedure are programmed into control
modules via a Techline Tech 2(R) scan tool and TIS 2 Web with the calibration update. Use TIS 2 Web version 4.5 for 2007 (available on 4/17/07) and
on TIS DVD version 5.0/2007 or later, which was mailed to dealers on 5/09/07. If you cannot access the calibration, call the Techline Customer Support
Center and it will be provided.

Service Procedure

The "Required Field Actions" section of the GM Vehicle Inquiry System (GMVIS) must be checked to determine if a specific vehicle requires this
action. If GMVIS indicates that Emission Recall Bulletin 07153 remains 'open' and TCM reprogramming has not taken place, reprogram the TCM using
a Tech 2(R) scan tool with the calibration update from Techline Information System (TIS).

Recall - TCM Update For Shift Improvements|Page 741 > < Tire Monitor System - TPM Sensor Information