Cobalt L4-2.4L VIN B (2006)
2. Connect the roof rail module - left connector to the vehicle harness connector.
3. Install the CPA to the roof rail module - left connector.
4. Install the garnish molding to the left upper lock pillar.
5. Connect the seat belt retractor pretensioner - LF connector.
6. Install the CPA to the seat belt retractor pretensioner - LF connector.
7. Install the left/driver lower center pillar trim.
8. Connect the steering wheel module coil connector to the vehicle harness connector.
9. Install the CPA to the steering wheel module coil connector.