Cobalt L4-2.4L VIN B (2006)
1. Install the brake caliper mounting bracket to the steering knuckle.
Notice: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard
tap. If a standard tap is used, damage to the joint threads will occur.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake caliper mounting bracket bolts (1).
^
Tighten the bolts to 115 Nm (85 ft. lbs.).
3. Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces of the caliper bracket (2) only.
4. Clean the brake pad mating surfaces of the brake pad retainers (1).
5. Install the brake pad retainers (1) to the brake caliper bracket.
Important: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake
rotor during forward wheel rotation, or at the top of the pad when installed in vehicle position.
6. Install the brake pads to the brake caliper bracket.
7. Remove the support and reposition the brake caliper over the brake pads and to the mounting bracket.