Cobalt L4-2.4L VIN B (2006)
4. If equipped with RPO LSJ, remove the coolant heater clip nut (1).
5. Remove the heater cord clip (2) from the shock tower stud (3).
6. Remove the coolant heater cord.
Installation Procedure
1. Install the coolant heater cord.
2. If equipped with RPO LSJ, install the heater cord clip (2) to the shock tower stud (3).
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the coolant heater clip nut (1).
^
Tighten the nut to 10 Nm (89 inch lbs.).