Cobalt L4-2.4L VIN B (2006)
5. Install the small balance shaft drive chain guide and bolts.
^
Tighten the bolts to 15 Nm (11 ft. lbs.).
6. Install the adjustable balance shaft chain guide and bolt.
^
Tighten the bolt to 10 Nm (89 inch lbs.).
7. Reset the timing chain tensioner by performing the following steps:
^
Rotate the tensioner plunger 90 degrees in its bore and compress the plunger.
^
Rotate the tensioner back to the original 12 o'clock position and insert a paper clip through the hole in the plunger body and into the hose in the
tensioner plunger.
8. Install the balance shaft drive chain tensioner and bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
9. Remove the paper clip from the balance shaft drive chain tensioner.