Cobalt L4-2.4L VIN B (2006)
5. Remove the blower motor and cup from the lower case by cutting through the case between the circular ribs around the motor with a sharp utility
knife.
IMPORTANT: Cut through the case as straight as possible because the motor cup must be replaced. In order to prevent damage to the component,
do not cut any deeper than necessary to remove the motor cup.
6. Release the blower motor retaining tab and remove the motor from the cup.
INSTALLATION PROCEDURE
1. Install the blower motor (1) into the motor cup (2) that was cut out of the lower case.
2. Install the blower motor nuts (3).
Tighten the nuts to 2.4 N.m (21 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Attach the service ring (4) to the motor cup (2) with the screws (5) included in the kit.
Tighten the screws to 1.8 N.m (15 lb in).
4. Install the blower motor and service ring into the HVAC module using the screws (5) included in the kit. Make certain the blower motor electrical
connector is pointing rearward in the vehicle.