Cobalt L4-2.4L VIN B (2006)
4. Carefully remove the ECT sensor.
INSTALLATION PROCEDURE
NOTE:
-
Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound,
lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings
already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the
operation of the component. Use the correct torque specification when installing components in order to avoid damage.
-
Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
1. If you are reinstalling the original sensor, or if you are installing a NEW sensor without a sealer, coat the threads with sealer Saturn P/N 21485278
or equivalent.
2. Install the ECT sensor.
NOTE: Refer to Fastener Notice.
Tighten the sensor to 10 N.m (89 lb in).