Cobalt L4-2.4L VIN B (2006)
2. Connect the front end sensor connector to the front end sensor (2).
3. Connect the CPA to the front end sensor connector.
4. Install the AIR BAG (1) and SDM (2) fuses into the BCM fuse center.
5. Install the BCM fuse center cover.
6. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
7. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle.