Cobalt L4-2.4L VIN B (2006)
10. Install the driver/left outer trim cover to the I/P.
11. Connect the I/P module connector (1) to the vehicle harness connector (2).
12. Install the CPA to the I/P module connector (1).
13. Install the passenger/right outer trim cover to the I/P (3).
14. Connect the seat belt retractor pretensioner - RF connector.
15. Install the CPA to the seat belt retractor pretensioner - RF connector.
16. Install the right lower center pillar trim.
17. Connect the roof rail module - right connector to the vehicle harness connector.
18. Install the CPA to the roof rail module - right connector.
19. Install the garnish molding to the right upper lock pillar.