Cobalt L4-2.4L VIN B (2006)
8. Place approximately half of the grease from the service kit in the inboard seal. Use the remainder of the grease to repack the housing.
Important: Ensure the trilobal tripot bushing (3) is flush with the face of the housing (1).
9. Install the new trilobal tripot bushing (3) to housing (1).
10. Position the larger new seal retaining clamp (2) on the inboard seal.
11. Slide the housing (1) over the tripot joint spider assembly on the shaft.
12. Slide the large diameter of the inboard seal (2), with the larger clamp (3) in place, over the outside of the trilobal tripot bushing and locate the lip
of the seal in the groove.
Important: The inboard seal must not be dimpled, stretched out or out of shape in any way. If the inboard seal is not shaped correctly, carefully
insert a thin flat blunt tool, no sharp edges, between the large seal opening and the trilobal tripot bushing in order to equalize the pressure. Shape