Cobalt L4-2.4L VIN B (2006)
3. The swage ring is swaged using J 41048 by the following method:
1. Position the outboard end of the wheel drive shaft assembly (1) in J 41048.
2. Align the swage ring.
3. Place the top half of J 41048 on the lower half of J 41048.
Notice: Refer to Fastener Notice.
Important: Align the following items during this procedure:
^
The outboard seal (1)
^
The shaft
^
The swage ring
4. Insert the bolts (2) and tighten by hand until snug.
^
Tighten each bolt 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.