Cobalt L4-2.4L VIN B (2006)
4. Remove the rear transaxle mount bracket to transaxle bolts.
5. Remove the rear transaxle mount bracket from the transaxle.
Installation Procedure
1. Install the rear transaxle mount to transaxle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Using the following sequence, install the rear transaxle mount bracket bolts:
1. Tighten the middle bolt to 60 Nm (44 ft. lbs.).
2. Tighten the lower bolt to 60 Nm (44 ft. lbs.).
3. Tighten the upper bolt to 60 Nm (44 ft. lbs.).