Colorado 2WD L4-2.8L VIN 8 (2004)
11. Remove the brake rotor and the wheel hub/bearing as an assembly while routing the wheel speed sensor harness through the steering knuckle.
Important: Note that the wheel speed sensor harness is positioned at the narrowest span between the wheel hub/bearing bolt holes.
12. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the wheel hub/bearing assembly.
Important: DO NOT lever or pry against the wheel speed sensor tone wheel under the wheel speed sensor. Lever against the wheel hub ONLY.
13. Using a suitable tool, pry or lever the wheel speed sensor off of the wheel hub/bearing housing.
Discard the wheel speed sensor.
Installation Procedure
Important: Align the wheel speed sensor harness with the reference mark on the wheel hub/bearing assembly between the bolt holes narrowest
span.