Colorado 2WD L4-2.8L VIN 8 (2004)
1. Install the engine mount. You will need to articulate the mount in order to install the mount.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount bolts.
3. To aid in the installation of the bolts, start a bolt in position (1) first.
^
Tighten the engine mount bolts to 50 Nm (37 ft. lbs.).
4. Lower the engine.
5. Install the engine mount-to-frame bracket through bolt.
^
Tighten both of the engine mount-to-frame bracket bolts to 85 Nm (63 ft. lbs.).
6. Remove the jack stand.
7. Install the engine shield if equipped.
8. Install the wheel and tire assembly
9. Lower the vehicle.