Colorado 2WD L4-2.8L VIN 8 (2004)
5. Lightly lubricate the crankshaft rear oil seal lip with clean engine oil.
6. Position the plastic installation sleeve supplied with the new seal to the crankshaft.
7. Use the J 44215 with the J 8092 and a hammer to install the crankshaft rear oil seal into the crankshaft rear oil seal housing.
^
The spring side of the seal goes toward the engine.
^
Ensure the seal is installed square.
^
The seal will bottom out in the housing when fully installed.
8. Install the flywheel.