Colorado 2WD L4-2.8L VIN 8 (2004)
1. Install a new O-ring seal to the actuator solenoid valve (2).
2. Lightly lubricate the O-ring seal with clean engine oil.
3. Install the CMP actuator solenoid valve (2) into the cylinder head.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the camshaft position actuator solenoid valve bolt (3).
Tighten
Tighten the CMP actuator solenoid valve bolt to 10 N.m (89 lb in).
5. Connect the engine wiring harness electrical connector (1) to the CMP actuator solenoid valve (6).
