Colorado 2WD L4-2.8L VIN 8 (2004)
10. Remove the ignition coils from the camshaft cover.
INSTALLATION PROCEDURE
IMPORTANT: Ensure the ignition coil seals are properly seated to the camshaft cover.
1. Install the ignition coils into the camshaft cover.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the ignition coil bolts.
Tighten
Tighten the ignition coil bolts to 10 N.m (89 lb in).
3. Attach the engine wiring harness conduit to the camshaft cover.