Colorado 2WD L4-2.8L VIN 8 (2004)
1. Slide the multifunction switch/SIR coil assembly (2) onto the steering column.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Screw the 3 pan head tapping screws (1) into the multifunction switch/SIR coil assembly (2).
Tighten
Tighten the screws (1) to 3 N.m (30 lb in).
3. Route the wire harness assembly down the steering column.
4. Connect the multifunction switch/SIR coil assembly connector at the base of the column.
5. Install the wire harness straps to the wire harness assembly.
6. Remove the centering tab from the multifunction switch/SIR coil assembly.
7. Install the steering column trim covers.
8. Install the steering wheel to the steering column.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.