Colorado 2WD L4-2.8L VIN 8 (2004)
Important:
On 2WD models, DO NOT replace the front coil spring(s) or add insulators to compensate for a low trim Z height. A lower trim Z height
reading is acceptable as long as it is within specification. Refer to Trim Height Inspection Procedure.
4.
Check and adjust the vehicle Z height.
Important:
ON 2WD models, ONLY replace the front coil spring(s) if the trim Z height is too low and out of specification.
5.
ON 2WD models, ONLY replace the front coil spring(s) if the trim Z height is too low and out of specification.
6.
Check and adjust the vehicle front toe to 0.00° +/- 0.20°.
7.
Road test the vehicle in order to verify that the steering wheel is straight.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer