Colorado 2WD L4-2.8L VIN 8 (2004)
Notice: Refer to Fastener Notice in Service Precautions.
4. Connect the lower ball joint to the steering knuckle and install the retaining nut.
^
Tighten the nut to 145 Nm (107 ft. lbs.).
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
^
Tighten the nut to 75 Nm (55 ft. lbs.).
6. Connect the outer tie rod to the steering knuckle.
7. Install the wheel hub and bearing assembly.
8. Install the tire and wheel.
9. Remove the lower control arm support.
10. Lower the vehicle.
11. Verify the wheel alignment.